Doremi V1-HD, User Manual

Page: 38 / 88

V_1.OM.000160.DRM Page 38 Version 5.0
Doremi Labs, Inc.
Connections :
1. Feed the HDSDI signal from the camera to the HDSDI input of the V1-HD.
Operation using a SloMo controller:
1. If you want your SloMo device to control the recorder channel, connect it to RS422-1 on
the back of the V1-HD
2. Connect your SloMo controller to RS422-2 on the back of the unit, which will control the
player channel.
3. Follow the operating instructions of your SloMo controller
Operation using the V1 front panel (RCV2 controller):
1. Go to the CONTROLLER MENU (06) and select Slomo Mode to ON .
2. Press the 1 button to select the Recorder. Locate to 0 and start recording
3. Press the 2 button to select the Player.
4. Press the RECORD button to go in EE mode. When you see an event worth marking
press SAVE , this will increment the segment number and save the IN point of the
segment minus the Preroll value setting. (The Preroll value is set in the CONTROLLER
MENU 05). Every time you press SAVE , the segment number will increment and the
new time code will be captured. If you want to recall a specific segment press the ++ or -
- buttons until you see the desired segment number displayed, then press RECALL .
(You can do this while in EE mode).
5. When you press SLOMO , the unit will start playing from that point at the slow motion
speed selected by the shuttle wheel.
6. To stop and go back in EE, press STOP followed by the Record button.
7.6 Audio Post
This section describes general connection procedures to digital audio workstations (DAW). It
also details several popular applications used in Audio Post.
7.6.1 Most Common Connection
This connection scheme is used to connect the V1 to Audiofile, Audiovision, Dyaxis II, Post-Pro,
Protools 4.0, StudioFrame, etc. For detailed instructions on your specific DAW refer to the
Appendix.
1. Feed house sync to the V1 and the DAW.
2. Connect the time code out of the V1 to the time code input of the DAW.
3. Connect the serial cable between the V1 RS422 port 1 and the DAW.
4. Run the DAW software which will control the V1.