V_1.OM.000160.DRM
Page 37
Version 5.0
Doremi Labs, Inc.
Operation:
All menus are pre-configured at the factory. Just make sure that
LOOP MODE
is set to
ON
on
the Recorder and on the Player:
1. Press the
1
button to select the Recorder.
2. Go to Menu 7 and make sure that the available recording time exceeds the duration of
the delay. If not, press
OPTION
CLEAR
and erase previous CLIPs one by one until the
remaining time in Menu 7 exceeds the duration of the delay.
3. Go to OPTION MENU (3) and set the
Dur
: to a value that exceeds your delay by 30
seconds and hit
ENTER
, then press
ESCAPE
.
4. Hold the
OPTION
key and press
SAVE
, then hit
ENTER
to accept the CLIP
name assigned by RCV2.
5. Press the
2
button to select Player 1
6. Hold the
OPTION
key and press
RECALL
, then turn the JOG WHEEL until you see the
CLIP you just created in step 4, then press
ENTER
to load the CLIP on Player 1.
7. Hold the
ESCAPE
Button and press the
Up Arrow
key
8. Keep pressing the
Up Arrow
Key until you see
Delay
9. Press the
TOGGLE
button and enter 01:00:00:00 (or any other delay) using the numeric
keypad then press the
ENTER
button. This will locate both recorder and player to 0 time
code. The recorder will start recording and the player will wait for an hour (or any value
set in delay), then it will start playing.
10. Press the
ESCAPE
button
To end the time delay operation, select the record channel (channel 1), go to the
CONTROLLER MENU (04)
Delay Mode
and press the
TOGGLE
button.
To stop the playback but keep the V1 recording, select the playback channel, go to the
CONTROLLER MENU (04)
Delay Mode
and press the
TOGGLE
button.
7.5 Slow Motion Replay: V1-HD Only
This paragraph describes how to set the V1-HD for slow motion replay applications.
This is
only available on early model V1-HD with the independent record and play option.
Ensure that Channel-1 is in 1R-1P mode by checking OPTION MENU (00).
The
1, 2, 3, 4
buttons on the front panel of the unit will allow access to the channels:
•
Button
1
will select the Recorder
•
Button
2
will select the Player
•
Buttons
3
and
4
have no effect
Setup:
1. Go to the OPTION MENU (1)
Transport
and set FrameMod to “off”.
2. Go to the OPTION MENU (1)
Transport
and set PL1Field<% to “0”.
3. Go to the OPTION MENU (5)
Save Setngs
to save the settings above.
