V_1.OM.000160.DRM
Page 25
Version 5.0
Doremi Labs, Inc.
FF
Fast forward control button with a speed of 40 times normal.
When the fast forward is close to the end of the recording, the
speed is slowed down to normal until it reaches the end. Pressing
this button again will increase the speed. There are three speed
levels FF+FF+FF.
OPTION
+
REW
Reverse Play. Holding
OPTION
and then pressing
REW
will
cause the V1 to play video at 100% reverse speed.
OPTION
+
PLAY
Executes the Chase Command. Hold
OPTION
and press
PLAY
.
See
6.5
.
5.2.4 LCD Time Code Display
Figure 20: LCD Time Code Display
The First line of the display shows the following:
•
Time location of the video material using the following format: “
HH:MM:SS:FF F1/F2”
•
"HH" represent the hours from 00 to 23, "MM" represent the minutes from 00 to 59, "SS"
represents the seconds from 00 to 59, "FF" represents the frames from 00 to 24 in PAL
frame-rates, 00 to 29 in NTSC frame-rates and 00 to 23 in 24P-48i frame-rates - "F1/F2"
represent the field: "F1" for odd fields and "F2" for even fields.
•
This display shows the
Time Code
depending upon what the user has selected in
MENU (2)
Time Mode
. The display also shows Drop/NonDrop information; “.” Means
NonDrop and “;” means DROP frame. Field one shows “.” Field two shows “:” or “;”
The Second line displays the following:
•
At the V1 start-up, the bottom left displays the firmware version of the V1, then
No Disk
and
Scanning
messages will alternate on the left side, then
No MD Found
and
Scanning
messages will alternate once a disk is detected and
Stop
is displayed on the
right side. Once a valid drive is recognized on the SCSI bus of the V1.
No Disk/No MD
Found
will disappear and only
Stop
will be displayed indicating that the V1 is now ready
to access the drive. If
No Disk/Scanning
is still displayed even though a disk was
installed, the V1 did not recognize the disk. If No MD Found / Scanning is still displayed,
it is an indication that the V1 has detected a disk but it cannot be mounted – refer to
paragraph
14.7
for details.
•
During transport controls, the current operation is shown on the right side of the display:
Servo-Lock Dot, PLAY, STOP, REWIND, FORWARD, RECORD, JOG, SHUTTLE,
VAR.
"VAR" is indicated during play in chase on LTC/MTC or in variable speed from RS422.
•
During shuttle movement, the shuttle speed is shown as:
If forward shuttle:
">> xx %"
with xx % = 10%, 20%, 50%, 100%, 200%, 500%, 1000%
If reverse shuttle:
"<< xx %"
with xx % = 10%, 20%, 50%, 100%, 200%, 500%, 1000%
