V_1.OM.000160.DRM
Page 50
Version 5.0
Doremi Labs, Inc.
LimToSeg
Limit to Segment; specifies the operation of “Loop Mode” below. When
“LoopMode” is set to
ON
, the V1 will record (play) in a loop specified by the
segment number. If the segment selected in this option is 0, the loop will be
the entire length of the file (24 hours).
LoopMode
Select
OFF
or
ON
. When ON the V1 will loop back to beginning of the file
when it reaches the end of the file or segment as specified in “LimToSeg”
above. When set to OFF the V1 will stop at the end of the file.
Emulate
Select
V1
(default),
BVW-75
,
DVW-500
,
Odetics
,
Odetics LMTD
,
VDCP
(Louth) or
RS-232C
.
StepRec
This option is for Step Recording. When enabled, every time the V1 goes
into record, it will only record one frame. This option is useful for animation.
When Step Recording is disabled, the V1 is in normal mode of operation.
Select
ALL
to record the video and audio. If you want to record video only
without altering the previously recorded audio, select
Video.
Rec at
The function tells the V1 to record at the current position (
Cur P.
) or at the
end of the last recorded video in the file (
End F.
). If you are working in any
of the A-Time modes and want to avoid recording over existing material, set
this option to
End F.
Note
: Rec at: End F. is not valid if the Time Mode is set to Time Code. In
those this mode, the unit will synchronize to the incoming time code to
determine the recording position.
10.2 Auto Play
The Auto Play settings allow the V1 to automatically start playing a segment when the V1 is
powered on and the drive is mounted.
Auto Play
Enter a predefined segment number
.
The V1 will now play that segment
every time it mounts that drive. This function can also be used to
automatically locate to a start point every time the disk is mounted. All you
need to do is set the
IN
and
OUT
time at the same location for the auto-
play segment.
NoVidDly 000s
V1 Screen Saver.
This parameter sets the delay until the video output goes
black (screen saver) in 10 seconds increments. "000" will disable this
feature. Example: "010" will cause the unit to output black video when the
unit is idle for 10 seconds.
10.3 New Rec Set
The New Record Settings contain all the main options used to define a V1 File.
If you are using multiple files on the V1 you must create a new file after changing a setting in
this section. For instructions on how to create a file,
see paragraph
6.1.2
.
If you are using a single file (the default file created by the V1) you will need to reinitialize after
changing a setting in this section -
See section
10.7
.
