78
A d d i n g Pa r t s
www
.dell.com | support.dell.com
Adding Cards
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions on page 9.
1
Shut down the computer through the
Start
menu (see page 27).
2
Ensure that your computer and attached devices are turned off. If your computer and
attached devices did not automatically turn off when you shut down your computer,
turn them off now.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then
unplug it from the network wall jack.
3
Disconnect any telephone or telecommunication lines from the computer.
4
Disconnect your computer and all attached devices from their electrical outlets, and
then press the power button to ground the system board.
CAUTION: To guard against electrical shock, always unplug your computer from
the electrical outlet before opening the cover.
5
Remove the computer cover (see page 74).
6
Lay the computer on its side so that the system board is on the bottom of the inside of
the computer.
7
Unscrew and remove the filler bracket for the card slot you want to use.
CAUTION: Some network adapters automatically start the computer when they
are connected to a network. To guard against electrical shock, be sure to unplug
your computer from its electrical outlet before installing any cards.
filler bracket
securing screw
J2936bk0.book Page 78 Tuesday, September 2, 2003 3:06 PM
