76
C o n f i g u r i n g t h e Po w e r C o n n e c t 3 3 2 4 / 3 3 4 8 S w i t c h
www
.dell.com | support.dell.com
4
Select Unit 2 using the
Stack ID
button within 15 seconds.
5
Repeat steps 3 and 4 for all stacking members.
NOTE:
Stack the units according to their Unit ID. For example, the Master Unit is stacked
first, with Unit 2 directly below the Master Unit.
Expanding the Stack
This section contains instructions for adding stacking members. To expand a stack:
NOTE:
The Stack Unit ID must be selected within 15 seconds.
1
Ensure that the stack is operating correctly.
2
Connect the lower Stacking connector to the additional stacking Member unit.
3
Plug in new stacking unit. The device begins to boot.
4
Select the unit number using the
Stack ID
button within 15 seconds.
5
For each new member, open the existing ring and connect the new member’s Stacking
cable.
For information on replacing stacking members and reassigning Unit IDs, see "
Replacing
Stack Members
".
Rebooting the Device
NOTE:
Before rebooting the device, save the device configuration. After the device is reset, all
unsaved configuration changes are lost.
1
Enter the CLI mode. The following prompt displays:
Console > enable
2
Enter
Reload
. The following message displays:
>reload
This command will restart the whole system and disconnect your
current session. Do you want to continue?
3
Enter
Y
. The device reboots.