C o n f i g u r i n g S w i t c h I n f o r m a t i o n
239
3
Select an interface in the
Copy Parameters from
field.
4
Select the interfaces to which the GARP Timers information is copied in the
Copy To
fields.
Defining GARP Timers Using CLI Commands
The following table summarizes the equivalent CLI commands for defining GARP timers
as displayed in the
GARP Timers
page.
The following is an example of the CLI commands:
Console (config)# interface ethernet 1/e8
Console (config-if)# garp timer leave 900
Configuring the Spanning Tree Protocol
The Spanning Tree Protocol (STP) provides a single path between end stations on a Layer 2
network, thereby eliminating loops.
Loops occur when alternate routes exist between hosts. Loops in an extended network may
cause bridges to forward traffic indefinitely, resulting in increased traffic and a reduction in
network performance. To open the
Spanning Tree
page:
•
Click
Switch > Spanning Tree
in the Tree View. The
Spanning Tree
page opens.
CLI Command
Description
garp timer {join | leave |
leaveall}
timer_value
Sets the GARP application join, leave, and
leaveall GARP timer values.
