C o n f i g u r i n g S w i t c h I n f o r m a t i o n
213
P o r t s C o n f i g u r a t i o n Ta b l e
In addition to the
Port Configuration
page fields, the
Port Configuration Table
also
displays the following field:
•
Unit Number
—Indicates the stacking unit number for which the port information is
displayed.
Configuring Ports with CLI Commands
The following examples describe how to set a port to MDIX or MDI mode. To set a port to
MDIX mode, enter the following at the system prompt:
console(config-if)# mdix on
The following message displays:
console # show inter config ethernet 1/e1
Flow
Admin Back
Mdix
Port Type
Duplex Speed Neg
Control State Pressure Mode
.......................................................
1/e1 100M-Copper
Enabled Off
Up
Disabled
On
To set a port to MDI mode, enter the following at the system prompt:
console(config)# inter eth 1/e1
console(config-if)# no mdix
The following message displays:
console # show inter config ethernet 1/e1
Flow
Admin Back
Mdix
Port Type
Duplex Speed Neg
Control State Pressure Mode
.......................................................
1/e1 100M-Copper
Enabled Off
Up
Disabled
Off
