DataDirect Networks EF2800, User Manual

Page: 145 / 381

122
DataDirect Networks EF2800 FC RAID Storage System User Guide (V 1.0)
O t h e r E F 2 8 0 0 C o n f i g u r a t i o n s
you are using software that your company developed to configure and
manage the controller (this application uses CAPI to communicate with
the controller), you must have a management LUN. If you are not using
software that your company developed, and therefore are not using CAPI,
select NONE as the management LUN. This allows your first array to be
seen at LUN 0.
To change the management LUNs:
1. From SAM, select
Manage EF2800
>
LUN Management
>
Change
SM LUN
. The Change SM LUN page displays.
2. Select the LUN you want to use for each SM:
Note : Use this setting if you are not using CAPI to configure the
EF2800.
Any number between 0 and 63: Select a specific number if you want
the management LUN to stay the same when you restart the
EF2800 (this change takes effect following a shutdown reboot).
3. Click
Change Management LUN
.
8.5 Changing the Alarm Mute Setting
You can enable or disable the audible alarm that sounds when the
EF2800 becomes too hot, detects low or high voltage, or an array
becomes critical or goes offline. Changing the mute setting lets you turn
off the alarm when it is sounding. You should turn it back on after
resolving the problem.
You can also use the Mute button on the EF2800 to turn off the alarm
when it sounds.
The alarm sounds for temperature or voltage conditions (events).
Warning events are generated when the temperature or voltage enters
the warning range. Shutdown events are generated when the
temperature or voltage enters the shutdown range. After reaching the
shutdown range, the EF2800 will not function. You must resolve the
problem and restart the EF2800. If the problem is not resolved, it will
shut down again.