164
Figure 3-162
Please enable the SNMP function. Use the corresponding software tool (MIB Builder and MG-SOFT MIB
Browser. You still need two MIB file: BASE-SNMP-MIB, NVR-SNMP-MIB) to connect to the device. User
may get the device corresponding configuration information after successfully connection.
Please follow the steps listed below to configure.
In Figure 3-162, check the box to enable the SNMP function. Input the IP address of the PC than is
running the software in the Trap address. User may use default setup for the rest items.
Compile the above mentioned two MIB file via the software MIB Builder.
Run MG-SOFT MIB Browser to load the file from the previous step to the software.
Input the device IP you want to manage in the MG-SOFT MIB Browser. Please set the corresponding
version for your future reference.
Open the tree list on the MG-SOFT MIB Browser; user may get the device configuration. Here user
may see the device has how many video channels, audio channels, application version and etc.
Note
Port conflict occurs when SNMP port and Trap port are the same.
3.15.1.10 Multicast
Multicast setup interface is shown as in Figure 3-163.
Summary of Contents for DNA3500 Series
