Daedong CK22, Workshop Manual

Page: 323 / 372

10-43 DS35-W00 May. 2007
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
ENGINEENGINEENGINEENGINEENGINE
HSTHSTHSTHSTHST
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
CK22/CK22H
25.Separate links by removing small Cir-clip securing
link to arm. Remove small Cir-clip retaining washer
and roller on arm.
26.Inspect component for wear or damage. Replace
as required.
Installation:
• Installation is the reverse of removal. Be sure to
pay attention to orientation of components when
assembling.
196W976A
(1) Cir-clip (6) Link
(2) Cir-clip (7) Cir-clip
(3) Support pin (8) Roller
(4) Arm (9) Plain washer
(5) Seal washer
19.Measure shaft (1) outside diameter and bore in
housing. Replace if not in specifications.
Shaft (1) Specifications:
21.95 mm (0.864 in.)
22.00 mm (0.866 in.)
O.D.
Bore I.D.
20.Inspect shaft (1), O-ring, stopper screw and lever
for damage or wear. Replace as required.
21.Remove Cir-clip (3) from pin (2).
22.Remove Cir-clip (1) from end of stud (4) on arm (5).
23.Unscrew pin (2) from outside of body making sure
that arm does not bind on shaft of pin during removal.
24.Slide link from stud end and remove link assembly
from body.
196W974A
196W975A
(1) Shaft (3) Stopper
(2) O-ring (4) Lever
(1) Cir-clip
(2) Pin
• Do not force components during disassembly or
assembly. Clearances are tight and components
must be free to move for depth control mecha-
nism to function correctly.
IMPORTANT
(3) Cir-clip
(4) Stud
(5) Arm
HYDRAULIC SYSTME - SERVICING