Daedong CK22, Workshop Manual

Page: 275 / 372

9-23 DS35-W00 May. 2007
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
ENGINEENGINEENGINEENGINEENGINE
HSTHSTHSTHSTHST
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
CK22/CK22H
14.Insert the drive shaft (1), into the motor so that its
slotted end engages the pin in the spool and sleeve.
Mark a line (2), on the face of the drive shaft that is
parallel to the pin and to the port face of the steering
motor housing (3).
15.Coat a new O-ring (2), and seal ring (3), with clean
hydraulic fluid and install on the rotor (1). Install a
new O-ring (4), in the groove on the stator, then fit
the rotor and stator together so that their O-ring are
on opposite sides.
NOTE:
• The orientation of the rotor and stator on the drive
shaft will determine valve timing in the steering
motor. These parts must be installed as described.
196W842A
196W843A
(1) Rotor (3) Seal ring
(2) O-ring (4) O-ring
13.Position the spool and sleeve so that the pin (1), is
parallel with the port face of the steering motor hous-
ing (3).
(1) Pin
(2) Spacer plate motor
(3) Port face of steering
196W841A
STEERING SYSTEM - SERVICING