Daedong CK22, Workshop Manual

Page: 329 / 372

10-49 DS35-W00 May. 2007
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
ENGINEENGINEENGINEENGINEENGINE
HSTHSTHSTHSTHST
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
CK22/CK22H
HYDRAULIC SYSTME - SERVICING
T46WAD5A
T46WAD6A
B. REASSEMBLY
Apply sufficient amount of oil to each part to prevent
any damage when installing them.
1. Be careful with the location of valves.
(1) Safety valve hole (4) Pilot valve hole
(2) Regulator piston hole (5) Drain hole
(3) Control spool hole (6) Bolt hole
2. When installing the regulator piston (1), insert the
end with orifice hole first.
3. When installing the safety valve, insert the steel ball
first. The convex side of the washer (1) should face
the spring. Install the washer with smaller I.D. in
inner side and apply small amount of grease on the
washer for proper seating.
T46WAD7A