Daedong CK22, Workshop Manual

Page: 207 / 372

5-21 DS35-W00 May. 2007
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
ENGINEENGINEENGINEENGINEENGINE
HSTHSTHSTHSTHST
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
CK22/CK22H
196W4B7A
11. Press a new oil seal (32) into the charge pump cas-
ing (51). Install the snap ring (33).
(32) Oil seal
(33) Snap ring
(51) Charge pump casing
12.Install items (50 and 53) and new O-ring into the
charge pump casing (51) and install items (51, 54,
55, 56) onto the housing and tighten (55) to a torque
of 26.5 ~ 32.4 Nm (2.7 ~ 3.3 kgf-m, 19.5 ~ 23.9 lb-ft).
8. Install the swash plate (15) into the housing, match-
ing the dowel in the housing with the hole in the
swash plate (15). Install the shoe plate (16) as
shown in the figure. Then, assemble items (17 ~
24) and install them onto the swash plate (16).
9. Apply petroleum jelly to the valve plates (45, 46) and
install them onto the rear cover (25).
10.Install items (25, 44, 47) and tighten (47) to a torque
of 44 ~ 54 Nm (4.49 ~ 5.51 kgf-m, 32.5 ~ 39.8 lb-ft).
• Make sure that the valve plates are installed into
the same position as removed in Hydrostatic
Transmission Disassembly.
IMPORTANT
HST - SERVICING