CR-MM-1-0-00
PS-28 Cruiser
PS-28N Cruiser
CHAPTER 15 – AIRPLANE REPAIRS
Date of issue: 2011-03-08
Revision No.: -
15 - 21
1. Adjust the correct position of
holes for locking wire.
6. Pull the upper wire through the
hole in the other bolt. Hold the
wire end by pliers and tighten it
firm.
2. Pull the locking wire through
the hole in one bolt to be secured.
7. Hold the free end of wire by
hand, bend it around the bolt head
and along with the other end twist
it counterclockwise.
3. Hold the upper end of the wire
and wind it around the bolt head
and then by the other end of the
wire. Make sure that the wire is
properly tightened around the
head.
8. Hold the twisted end by pliers
and twist it tight.
4. Twist the wire to the hole in the
next bolt so tight as possible.
9. Bend the end of the wire under
the bolt head.
5. Tighten the wire and at the
same time continue its twisting
unless perfectly tightened. The
twisted wire can have
approximately from 3 to 4 threads
on the length of 10 mm (
0,4 in
).
10. Cut off the surplus wire.
Fig. 15-7
: Procedure for securing the bolt joint with locking wire
