CTE B-LIFT PRO Series, Instructions For Use And Maintenance Manual, Page: 75 / 148

I n s t r u c t i o n s f o r U s e
a n d M a i n t e n a n c e
Section F
KNever exceed the maximum
capacity of the basket, especially
when the equipment is raised.
The lifting platform can be used
only when the vehicle is not
moving, with the brakes on, and
stabilised on level and consistent
ground.
The operator inside of the basket
must be assisted by a properly
trained person from the ground.
There must be no obstacles or
dangerous items in the basket's
operating area.
Carry out maintenance work
according to the timetable set out
in this manual, using work tools
that are appropriate and in good
condition.
Do not take substances that may
alter physical or mental abilities,
etc. (alcohol, medications).
If it is necessary to operate in
another work area, move the
machine with the equipment in
transportation mode.
Never deactivate the safety
devices to perform operations
which would otherwise be
impossible.
Never stop the lifting platform
abruptly unless it is for safety
reasons.
Never lean over the edge of the
basket while using the lifting
platform.
Always keep handles and foot-
rests free from oil and grease.
Leaving the control area on the
ground, while the operator is alo-
ne in the basket, is prohibited.
It is prohibited to remove covers
and/or casings, unless it is for
maintenance reasons.
Always wear protective helmet.
Keeping articulations raised
without a reason while not
working with the lifting platform is
prohibited.
Using the lifting platform under
conditions of poor visibility is
prohibited.
When travelling on roads that are
open to traffic, it is mandatory to
comply with highway traffic norms
that are in force in the country
where the platform is used.
Loading the basket with materials
and/or things once it has already
been raised is prohibited.
Using the lifting platform to raise
or move materials and/or things
is prohibited.
Accident-prevention Standards in
force must be respected during
work on the platform.
It is indispensable to verify the
perfect functioning and
maintenance status of all devices
before each use, following the
instructions found in the use and
maintenance manual.
Tampering with these devices is
absolutely prohibited; the penalty
for this is the requirement to
immediately stop using the
machine.
Verify and evaluate the safety of
actual work conditions (ground,
wind, levelling, etc).
Ensure that the work area free of
all obstacles, especially electrical
lines.
Coming close to live electrical
lines and equipment is prohibited.
Keep a safety distance that
agrees with national standards in
force. If the nominal voltage of the
line is unknown, always keep a
distance of at least 5 m.
It is mandatory to delimit the
boundaries of the area under the
work zone.
The operator must suspend
operations when unauthorised
personnel enter this area or that
of the vehicle platform.
General warnings