CTE B-LIFT PRO Series, Instructions For Use And Maintenance Manual, Page: 74 / 148

Instructions for Useand
M a i n t e n a n c e
Section F
2
ATTENTION
Read the following manual carefully before beginning operation.
This section describes the work cycle which, within reason, the lifting platform is expected to perform.
Any special situations and conditions which could arise for the operators, should be dealt with taking into
account and observing the machine’s limits (technical data) and, above all, ensuring that everything is
carried out with the utmost safety for the operators firstly and, then, for the machine too.
Introduction
Preliminary checks
Before beginning operation with the lifting platform, it is recommended that you carry out a series of checks,
both on the machine and on the area in which the machine will be placed.
In particular, to make work easier you must check that:
- the working area is marked off, indicated with signs and free of obstacles;
- the ground is sufficiently compact; if necessary, everything possible should be done to firm up the
ground (e.g.: increase the stabiliser cylinder support base);
- the safety systems are efficient (see Section E, safety system checks).
If one of these safety systems is damaged or malfunctioning, the platform must not be used;
you must report the fault to the nearest authorised CTE workshop.
- there is sufficient fuel;
- the batteries are in good working condition;
- The connections to the external networks have been carried out correctly;
- the path which the car has to take to reach the work point is free of obstacles.