![background image](http://html.mh-extra.com/html/conair/ch-series/ch-series_installation-manual_2649431017.webp)
Hopper Installation Guide
I
1-13
(Continued)
Installing the Hopper Door, Upper, and
Lid Sections
(continued)
Hopper Lid Section
IMPORTANT:
Improper mounting of the hopper lid will cause interference when
installing the DM-II monitor probe and optional integrated cyclone.
To install the hopper upper section(s):
1
Apply the supplied strip and
stick gasketing material around
the flange on the top of the
hopper door or hopper upper
section (whichever is applicable).
2
Using a forklift, hoist, or crane,
lift the hopper lid section
assembly above the hopper door
or hopper upper section.
3
Set the hopper lid section on
the hopper door or hopper
upper section as shown.
As the
hopper lid section is positioned on
the hopper door or hopper upper
section, make sure the holes in
the hopper lid section align with
the holes in the hopper door or
hopper upper section.
4
Secure the hopper lid section to
the hopper door or hopper upper
cone section
using the 3/8-inch
hardware supplied.
NOTE:
When applying the strip
and stick gasketing material,
do not cover the holes in the
hopper door section flange.
Apply the strip and stick gasket-
ing material around the holes
so you will have a good seal
but not interfere with the
mounting hardware that will
be used to secure the hopper
upper section to the hopper
door section.
TIP:
Conair recommends
applying strip and stick
gasketing material 1/4 inches
{6.35 mm} from the inside to the
edge of the hopper.
WARNING:
To
accomplish the following
steps, it may be necessary
for personnel to enter the
hopper assembly. If it is
necessary to enter the
hopper assembly, all appli-
cable OSHA procedures for
working within a confined
space
MUST BE
followed.
CAUTION:
To pre-
vent accident and injury,
lift the hopper upper
section onto the hopper
door section using a
forklift, hoist, or crane.
CAUTION:
Keep
hands clear of sections
coming together.