![background image](http://html.mh-extra.com/html/conair/ch-series/ch-series_installation-manual_2649431016.webp)
1-12
I
Hopper Installation Guide
NOTE:
When applying the strip
and stick gasketing material, do
not cover the holes in the cone
section flange. Apply the strip
and stick gasketing material
around the holes so you will
have a good seal but not inter-
fere with the mounting hard-
ware that will be used to
secure the hopper door section
to the cone section.
TIP:
Conair recommends
applying strip and stick
gasketing material 1/4 inches
{6.35 mm} from the inside to
the edge of the hopper.
Installing the Hopper Door, Upper, and
Lid Sections
(continued)
Hopper Upper Section(s) (If Applicable)
1
Apply the supplied strip and stick gasket around the flange on the top of the
hopper door section.
2
Using a forklift, hoist, or crane, lift the hopper upper section assembly above the
hopper door section.
CAUTION:
To prevent accident and injury, lift the hopper upper section onto
the hopper door section using a forklift, hoist, or crane.
CAUTION:
Keep hands clear of sections coming together.
IMPORTANT:
Line up the sight glasses of the hopper upper section(s) with the
sight glasses of the hopper door section.
3
Set the hopper upper section on the hopper door section.
As the hopper upper
section is positioned on the hopper door section, make sure the holes in the upper
section align with the holes in the door section.
4
Secure the hopper upper section to the hopper door section using the 3/8-inch
hardware supplied.
NOTE:
If more than one (1) hopper upper section is to be installed, repeat the steps detailed in this
section for each hopper upper section.
(Continued)