H P H e a t e r P a c k I n s t a l l a t i o n
( c o n t i n u e d )
39-inch and 44-inch Hopper
1
Attach the top flange of
the Heater Pack to the
underside of the top
hopper flange using the
three existing bolts
shown.
See Figures 18
and 19.
2
Attach the bottom of
the Heater Pack to the
hopper using the three
existing bolts shown
.
The bottom end of the
heater bracket will rest
on the lower hopper
flange above the inlet
tube. The elbow will attach with flexible ducting. See Figures 20 and 21.
3
Height adjustment of
the Heater Pack on
the bracket may be
required.
Adjust the
height (Figure 23) so
that the bottom of the
elbow on the Heater
Pack is aligned with the
hopper inlet. Adjust the
upper elbow as needed.
See Figure 22. Some adjustments may be made with the
hose connections between the heater tubes and manifolds.
NOTE:
The four nuts in
Figure 23 can be used to
adjust the bracket verti-
cally. The two bolts in
Figure 22 on each side
are used to adjust the
upper elbow support
piece.
✐
Figure 19
Figure 18
Figure 20
Figure 21
Figure 22
Figure 23
2
-
14
I
Hopper Installation Guide
(Continued)