![background image](http://html.mh-extra.com/html/conair/ch-series/ch-series_installation-manual_2649431033.webp)
H P H e a t e r P a c k I n s t a l l a t i o n
( c o n t i n u e d )
All Heater Packs
1
Connect the Heater Pack (HP) to the outlet of the dryer using flexible hosing and a
provided slip adapter
.
Connect the hopper exhaust tube to the inlet of the dryer
using flexible hosing and a provided slip adapter
. The exhaust tube can be mounted
on the same side of the hopper; it may differ based on different equipment arrangements.
2
Connect the HP terminal switch to
the dryer control box and wire the
Heater Pack power
. There is a termi-
nal switch similar to the picture in all
Heater Packs. Refer to the analog and
digital input sheets of the wiring dia-
gram for the control that comes with
the dryer.
3
Connect the Process RTD to the hopper inlet tube
. The Process Protection RTD will
connect to the manifold or elbow underneath the HP.
To Dryer
Inlet
From Dryer
Outlet
NOTE:
The exhaust will
mount to a cyclone if one
is present on the hopper.
✐
NOTE:
The connection
methods will be different
if hard piping is used.
There will be no exhaust
tube, and the HP will not
have an elbow on the top
of it.
✐
To order parts, Conair’s
Instant Access 24/7 Parts
and Service number is
800-458-1960.
Outside the U.S., dial
814-437-6861.
Hopper Installation Guide
I
2
-
15