![background image](http://html.mh-extra.com/html/conair/ch-series/ch-series_installation-manual_2649431011.webp)
Hopper Installation Guide
I
1-7
Location and Mounting of the HTC
Heater Assembly
(Models HTC 30, 60, and 90)
CAUTION:
You are responsible for the structural integrity of this installation.
NOTE:
The HTC control is shipped mounted on the left side of the Hopper floor stand on models
30, 60 and 90.
(see figure to the right)
NOTE:
The heater is prewired to the control box on HTC Model 30, 60 and 90.
Location and Mounting of the HTC
Heater Assembly
(Models HTC 120)
CAUTION:
You are responsible for the structural integrity of this installation.
1
Securely bolt the HTC heater assembly to the back of the floor stand
(see figure
to the right). Use the locking fasteners provided to securely mount the heater
assembly to the floor stand to prevent vibration-induced loosening.
NOTE:
The heater is prewired to the control box on HTC Model 120.
Location and Mounting of the HTC
Heater Assembly
(Models HTC 180 and 270)
CAUTION:
You are responsible for the structural integrity of this installation.
1
Securely bolt the HTC heater assembly to the back of the floor stand
(see figure to the right). Use the locking fasteners provided to securely mount the
heater assembly to the floor stand to prevent vibration-induced loosening.
2
Refer to the wiring diagram to make the wiring connections for the heater
and control box.
Only a qualified electrician should make the wiring connections
between the control and the heater. The customer must supply the appropriately-
sized wire and conduit to make connections.
IMPORTANT:
Always refer to the wiring
diagrams that came with
your HTC before making
electrical connections.
HTC Heater
CAUTION:
Always
disconnect and lock out
the main power sources
before making electrical
connections. Electrical
connections should be
made only by qualified
personnel.
CAUTION:
Check the
disconnect with a volt
meter to ensure that the
power is off.