Comtrol RocketLinx MP1204-XT, User Manual

Page: 30 / 414

30 - Configuring the IP Address RocketLinx MP1204-XT User Guide : 2000644 Rev. A
Using Telnet to Configure the IP Address
9. Enter
ip address ###.###.###.### ###.###.###.###
(the IP address – space – subnet mask) and press the Enter
key.
10. Enter exit and press the Enter key.
11. Enter
exit
and press the
Enter
key.
12. To save the IP address to the flash, enter copy running-config startup-config and press the Enter key.
You can now open the MP1204-XT web interface to configure it for your environment.
Using Telnet to Configure the IP Address
You must have the MP1204-XT connected to your network and you may need to change your IP address on
your system before you can telnet into the MP1204-XT.
Optionally, if you change your system IP address temporarily, you can use the web interface to configure the
IP address (
Using the Web Interface to Configure the IP Address on Page 31).
Note: The default IP address of the MP1204-XT is 192.168.250.250.
1. Open the command prompt and enter telnet 192.168.250.250.
2. Enter
admin
as the
Username
and press the Enter key.
3. Enter
admin
as the
Password
and press the
Enter
key.
4. Enter
enable
and press the
Enter
key.
5. Enter
configure terminal
and
press the
Enter
key.
6. Enter interface vlan 1 and
press the
Enter
key.
7. Enter
ip address
###.###.###.### ###.###.###.###
(the IP address – space –
subnet mask) and press the Enter key.
8. Move the Ethernet cable the appropriate network connection.
9. Close the telnet session.
10. To save the new IP address to the flash,
enter
telnet
and the new IP address.
11. Enter the
Username
and
Password
.
12. Enter
copy running-config startup-config
and press the Enter key.
13. If necessary, return your system IP
address.
You can now open the MP1204-XT web
interface to configure it for your environment.