122 - Configuration Pages
RocketLinx MP1204-XT User Guide
: 2000644 Rev. A
Configuration | MVR
MVR VID
Specify the Multicast VLAN ID.
Note:
MVR source ports are not recommended to be overlapped with management VLAN
ports.
MVR Name
The MVR Name is an optional attribute to indicate the name of the specific MVR VLAN.
Maximum length of the MVR VLAN Name string is 16. The MVR VLAN Name can only
contain alphabetic or number characters. When the optional MVR VLAN name is given,
it should contain at least one alphabetic character. The MVR VLAN name can be edited
for the existing MVR VLAN entries or it can be added to the new entries.
IGMP Address
Define the IPv4 address as source address used in IP header for IGMP control frames.
The default IGMP address is not set (0.0.0.0).
When the IGMP address is not set, the MP1204-XT uses IPv4 management address of
the IP interface associated with this VLAN.
When the IPv4 management address is not set, the MP1204-XT uses the first available
IPv4 management address.
Otherwise, the MP1204-XT uses a pre-defined value. By default, this value is
192.168.250.250.
Mode
Specify the MVR mode of operation. In
Dynamic
mode, MVR allows dynamic MVR
membership reports on source ports. In
Compatible
mode, MVR membership reports are
forbidden on source ports. The default is
Dynamic
mode.
Tagging
Specify whether the traversed IGMP/MLD control frames are sent as
Untagged
or
Tagged
with MVR VID. The default is
Tagged
.
Priority
Specify how the traversed IGMP/MLD control frames are sent in prioritized manner.
The default
Priority
is 0.
LLQI
Define the maximum time to wait for IGMP/MLD report memberships on a receiver port
before removing the port from the multicast group membership. The value is in units of
tenths of a seconds. The range is from 0 to 31744. The default LLQI is 5 tenths or one-
half second.
Interface
Channel
Profile
When the MVR VLAN is created, select the IPMC Profile as the channel filtering
condition for the specific MVR VLAN. A summary about the Interface Channel Profiling
(of the MVR VLAN) is shown by clicking the
view
button. The profile selected for
designated interface channel is not allowed to have overlapped permit group address.
Profile
Management
Button
You can inspect the rules of the designated profile by using the
view
button:
List the rules associated with the designated profile.
Port
The logical port for the settings.
Click to add a new MVR VLAN. Specify the VID and configure the new entry and then
click Save.
Item
Configuration | MVR (Continued)
Summary of Contents for RocketLinx MP1204-XT
Page 28: ...28 Installing the Hardware RocketLinx MP1204 XT User Guide 2000644 Rev A System Reset ...
Page 36: ...36 Web Interface Overview RocketLinx MP1204 XT User Guide 2000644 Rev A Ending a Session ...
Page 180: ...180 Configuration Pages RocketLinx MP1204 XT User Guide 2000644 Rev A Configuration DDMI ...
Page 414: ...414 Glossary RocketLinx MP1204 XT User Guide 2000644 Rev A Y ...
