CRS-500 1:N Redundancy System
Revision 4
Checklists for Initial Start-up and Configuration
3–4
MN-CRS-500
Step
Task (* User-provided equipment / ** Purchased Separately)
Chapter
Ref
5
Configure the CRS-500 CSU for 1:N Operation with the new modem:
8
Set Operating mode to Manual Switching mode.
8
Set IP address (for M&C to/from modems)
8
Set Redundancy Traffic IP address (if applicable)
8
Activate the new Traffic Modem.
8
Perform Redundancy System Checkout.
3
Set Operating Mode to Auto Switching Mode.
8
6
Connect RF* cables between either the CRS-500 ISU(s)** or the signal combiners, and the
RF Upconverters *.
5
DO NOT CONNECT the IF to any Upconverters UNTIL AFTER the CRS-500 1:N Redundancy
System is fully cabled and configured. Do this to prevent unintended signals from reaching the
satellite.
3.3.2
Remove a Traffic Modem from an Operating CRS-500 1:N
Redundancy System
Do these steps:
Step
Task (* User-provided equipment / ** Purchased Separately)
Chapter Ref
1
Use either the CSU Front Panel or the CRS-500 HTTP (Web Server) Interface to deactivate
the targeted Traffic Modem.
8
2
Power OFF the targeted Traffic Modem.
5
3
Disconnect the cables between the powered OFF modem and the CRS-500 System
components (CRS-500 CSU, DSU, and ISU(s), and other modems) and equipment *.
5
4
Remove the modem from its location in the rack *.
4
Summary of Contents for CRS-500
