Comtech EF Data CRS-500, Installation And Operational Manual

Page: 177 / 220

CRS-500 1:N Redundancy System
Revision 4
Serial Interface Operation 10–13 MN-CRS-500
10.3.2 Unit Parameters Commands and Queries
Parameter
Type
Controller-to-Target
Instruction Code and Qualifier Arguments for
Command or
Query
Description of Arguments
(Note that all arguments are ASCII numeric codes – i.e.,
ASCII codes between 48 and 57)
Target-to-Controller
Command Query
Response to
Command
Response to Query
(see Description of
Arguments)
Firmware
Boot From
Slot
BFR= BFR? 1 byte Command or Query.
Sets or returns the bulk firmware slot to boot from in the form x, where:
1 = Firmware is Slot #1
2 = Firmware is Slot #2
3 = Latest Firmware (most recent release date)
BFR=
BFR?
BFR*
BFR#
BFR=x
Current
Firmware
Image
IMG= IMG? 1 byte Query Only.
Returns the active firmware image in the form x, where:
1 = Bulk Image #1 currently active
2 = Bulk Image #2 currently active
IMG=
IMG?
IMG*
IMG#
IMG=x
Management
IP Address
IPA= IPA? 20 bytes Command or Query.
Sets or returns the IP Address and Subnet Mask for the 10/100 BaseTx Ethernet
Management Port in the form xxx.xxx.xxx.xxxyy, where:
xxx.xxx.xxx.xxx = IP Address, and
yy = Subnet Mask (00 through 31)
COMMAND EXAMPLE: <0000/IPA = 010.006.030.001/24{CR} means set the
Management IP Address for the Switch to 10.6.30.1 with a Subnet Mask of 24.
IPA=
IPA?
IPA*
IPA#
IPA=xxx.xxx.xxx.xxxyy
Gateway IP
Address
IPG= IPG? 15 bytes Command or Query.
Sets or returns the IP Gateway Address for the Ethernet Management Port in the
form aaa.bbb.ccc.ddd, where (permitted ranges are specified, but they cannot all be
zero):
aaa = 0-223
bbb = 0-255
ccc = 0-255
ddd = 0-255
NOTES:
The Gateway IP Address must be on the same subnet as the Management IP
Address.
The Gateway IP Address can be cleared by setting it to 0.0.0.0
COMMAND EXAMPLE: <0000/IPG = 010.006.030.002
IPG=
IPG?
IPG*
IPG#
IPG=xxx.xxx.xxx.xxx