CRS-500 1:N Redundancy System
Revision 4
Cables and Connections
5–2
MN-CRS-500
For all user-fabricated cables, the cables required between each modem and Switch plug-in RMI
or TMI module should be of shielded, twisted-pair construction, with the grounded shield bonded
to the back shell. Wire all data cables correctly using the connector and pinout information
provided in
Appendix A. CABLE DRAWINGS
or
Appendix B. CONTROLLER
/
TMI
CONNECTORS
AND
PINOUTS
.
The following illustrations featured in this chapter provide cabling configuration examples for RMI
or TMI interfaces – i.e., the interconnection of the Redundant Modem to a CRS-500 DSU-
mounted RMI module, or the interconnection between a CRS-500 DSU-mounted TMI module and
a Traffic Modem. See
Section 1.3.2 Data Switch Unit (DSU)
in
Chapter 1. INTRODUCTION
for
an overview about these interfaces.
Summary of Contents for CRS-500
