Compro Technology TN2200, User Manual

Page: 15 / 76

3-3 Wall / Ceiling Mount Wall / Ceiling Mount
Chapter 3: Installtion
Without Using Wall Mount Base
1. Use the supplied hex key to remove the top cover.
Rubber O-ring
Figure 3-7. Remove top cover
2. Drill 2 mounting holes on the mounting surface. The 2 screw holes should be spaced exactly 80 mm (3.15
inch) apart to correspond to the position of mounting holes on the camera. (Or use the supplied drill
template B to drill the mounting holes.) Then drill a cable hole if you need to run the cable through the
mounting surface.
Rubber O-ring
80 mm
Cable Hole
Figure 3-8. Drill mounting holes
3. Fix the camera to the mounting surface with the supplied self-tapping screws. Make sure you use a sup-
plied rubber O-ring in between the screws and the screw holes (as circled) to avoid moisture entering
the casing. Finally, re-attach the camera’s top cover and secure the screws tightly with the supplied hex
key.