Caravan equipment
67
O
w
ners h
andb
o
ok
2
02
2
Set up Antimicrobial function
To actively kill Legionella, set up the
Antimicrobial function. At 2:00 every
night, the hot water will be heated to
over 65°C for 30 mins. This further
reduces the risk of Legionella.
1. Press Tool button to access the
Settings Menu (bottom right in
Main Menu).
2. Press down arrow, until Antimicrobial
button is displayed.
3. Press Antimicrobial button to proceed.
Setup Standby Screen for bedtime
The backlight on the Standby Screen
can be disturbing if the control panel is
visible from your bed. It can be inverted
for white text on black background.
1. Press Tool button to access the
Settings Menu (bottom right in
Main Menu).
2. Press down arrow, until Backlight
button is displayed.
3. Press Backlight button, select
Inverted to proceed.
Maintenance
The Alde control panel requires no
maintenance, other than cleaning of the
screen as needed. Use a microfibre cloth
to clean the touchscreen.
Troubleshooting
Any error messages will be displayed on
the Standby Screen. Error messages can
be cleared by switching off 12V supply to
the boiler for 10 secs.
The system is completely dead, the
control panel is blank
• Check the 20 mm T3.15 Amp glass fuse
in the boiler. This is located under the
lid of the black plastic service hatch, in
a green plastic fuse holder.
• Check the 12V supply to the boiler, it
should be above 12V.
• Check the 12V cable is plugged into the
boiler. Check the cable is plugged into
the Alde control panel.
“Panel failure 1” & “Panel failure 2”
• Moisture is trapped in the control panel.
• Remove the Alde control panel from
the vehicle and air in a warm, dry
place overnight.
“Gas failure”
• Out of gas or gas is not igniting.
• Check the gas cylinder is full. Try a
different gas cylinder, ensuring it is
propane gas.
“Overheat red fail” or “Overheat blue
fail”
• Bleed the system of air.
• Check the fluid level in the expansion
tank. It should be 1cm above Min mark
when cool.
