Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 170 / 414

13
Tow/Run Switch
ELECTRIC VEHICLE - ELECTRICAL
COMPONENTS
1
3
5
2
4
707
Figure 13-5 Access and Remove Electronics Module Cover
TOW/RUN SWITCH
See General Warnings on page 1-2.
TESTING THE TOW/RUN SWITCH
See Test Procedure 3 – Tow/Run Switch on page 12-14.
TOW/RUN SWITCH REMOVAL
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2. Remove the electronics module cover to access back side of the Tow/Run switch (2). See Electronics Module
Cover Removal on page 13-5.
3. Remove Tow/Run switch boot/hex nut (1) (Figure 13-6, Page 13-7) .
4. Remove Tow/Run switch (2) from electronics module and disconnect the pink wire (3) and light green wire (4).
TOW/RUN SWITCH INSTALLATION
1. Installation is reverse of removal. Make sure flat on switch is aligned with flat part of D-shaped hole in electronics
module
(Figure 13-6, Page 13-7) . Tighten Tow/Run switch boot/hex nut (1) to 16 in·lb (1.8 N·m).
2. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-4.
Page 13-6 2019 Precedent Villager 2 Maintenance and Service Manual