Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 171 / 414

ELECTRIC VEHICLE - ELECTRICAL
COMPONENTS Motor Controller Output Regulator (MCOR)
13
CAUTION
WARN
ING
WARNING
RUN
TOW
3
4
1
2
709
Figure 13-6 Tow/Run Switch
MOTOR CONTROLLER OUTPUT REGULATOR (MCOR)
See General Warnings on page 1-2.
TESTING THE MCOR
See Test Procedure 11 – MCOR Voltage on page 12-22 and Test Procedure 5 – Key Switch and MCOR Limit
Switch Circuit on page 12-16.
MCOR REMOVAL
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2. Remove pedal group. See Pedal Group Removal, Section 5, Page 5-1.
3. Disconnect the two-pin and three-pin connectors from the MCOR.
4. Remove the T25 torx screw securing the MCOR to the pedal group.
5. Detach the two tabs from the accelerator pedal and remove the MCOR from vehicle.
MCOR INSTALLATION
1. Align the two tabs of the MCOR (2) with the slots in the accelerator pedal on the pedal group. Insert the MCOR
into the accelerator pedal until the tabs engage.
See following NOTE.
NOTE: Rotate the pedal back and forth if necessary to align the D-shaped end of shaft with the MCOR.
2. Secure MCOR to pedal group with T25 torx screw. Tighten screw to 19 in·lb (2.1 N·m).
3. Connect the two-pin and three-pin connectors from the wire harness to the MCOR.
4. Install the pedal group. See Pedal Group Installation on page 5-3.
5. Connect the batteries. See Connecting the Batteries – Electric Vehicles on page 1-4.
2019 Precedent Villager 2 Maintenance and Service Manual Page 13-7