Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 47 / 414

SECTION 5 — ACCELERATOR AND BRAKE PEDAL GROUP
5
Accelerator and Brake Pedal Group
DANGER
• See General Warnings on page 1-2.
WARNING
• See General Warnings on page 1-2.
PEDAL GROUP – ELECTRIC VEHICLE
See General Warnings on page 1-2.
PEDAL GROUP REMOVAL
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2. Remove screws (1). Pull floor mat retainer (3) away from the vehicle (Figure 5-1, Page 5-1) .
3. Pull floor mat (2) over the pedal group to gain access to the pedal group hardware.
1
2
3
629
Figure 5-1 Pedal Group Access
4. Remove fastener (10) and lift off cover plate (7) (Figure 5-2, Page 5-2) .
5. Loosen jam nuts (4 and 5) on each side of turnbuckle (6).
NOTE: Nut (4) has a left-hand thread.
6. Loosen turnbuckle (6) until the threaded rod (8) from the pedal group (11) is free of the turnbuckle (Figure 5-2,
Page 5-2) .
7. Remove two screws (2) on the driver side of the pedal group and two screws (1) on the passenger side of
the pedal group.
8. Disconnect the wire harness (12) from the MCOR (13).
9. Lift pedal group from vehicle.
2019 Precedent Villager 2 Maintenance and Service Manual Page 5-1