Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 39 / 414

BODY AND TRIM
Kick Plate and Charger Receptacle Bezel
– Electric Vehicles
4
KICK PLATE AND CHARGER RECEPTACLE BEZEL – ELECTRIC VEHICLES
See General Warnings on page 1-2.
KICK PLATE AND CHARGER RECEPTACLE BEZEL REMOVAL
1. If charger bezel (4) requires removal, use charger bezel tool to remove bezel from the kick plate (Figure 4-6,
Page 4-9) .
2. Remove floor mat. See Floor Mat and Retainers on page 4-8.
3. Remove three screws (1) that hold the kick plate (2) to the vehicle.
4. Remove the two front screws (3) that hold the beauty panel to the vehicle. Raise the forward portion of the rear
beauty panel to disengage it from the tabs on the upper portion of the kick plate.
5. Remove kick plate from vehicle.
KICK PLATE AND CHARGER RECEPTACLE BEZEL INSTALLATION
1. Position the kick plate (2) on the vehicle and secure with three screws (1) (Figure 4-6, Page 4-9) . Ensure front
lower edge of rear beauty panel mates with the kick plate. Tighten screws to 3.3 ft·lb (4.5 N·m).
2. Install two front screws (3) to secure the rear beauty panel. Tighten screws to 3.7 ft·lb (5 N·m).
3. Install floor mat. See Floor Mat and Retainers on page 4-8.
4. Snap charger bezel (4) in place on the kick plate.
1
4
2
3
655
Figure 4-6 Kick Plate and Charger Receptacle Bezel
2019 Precedent Villager 2 Maintenance and Service Manual Page 4-9