GASOLINE VEHICLE - ENGINE
General Information
20
2.
Check oil by fully inserting the dipstick into the oil filler tube and immediately removing it.
3.
If the oil level is at or below the low level mark on the dipstick gauge, add oil until the level is between low
and full levels (safe level).
4.
Insert the dipstick into the oil filler tube.
See following NOTE.
NOTE:
Properly recycle or dispose of used oil in accordance with local, state, and federal regulations.
1. Full level 2. Safe level 3. Low level
2662
Figure 20-1
Engine Oil Level Check
Engine Oil Change
Engine oil should be changed after the first 100 hours of operation. After that, it should be changed every 200
hours of operation or annually, whichever comes first.
1.
Turn the key switch to the OFF position, then remove the key. Place the Forward/Reverse handle in the
NEUTRAL position. Chock the front wheels.
2.
Access the engine compartment and place the Maintenance/Operate switch in the MAINTENANCE position.
3.
Disconnect battery and spark plug wire.
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
4.
Position a pan designed for oil changes under the drain plug (1)
.
2019 Precedent Villager 2 Maintenance and Service Manual
Page 20-3
Summary of Contents for Precedent Villager 2
