Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 215 / 414

ELECTRIC VEHICLE - MOTOR External Motor Testing
16
TEST PROCEDURE 3 – Field Circuit Open
See General Warnings on page 1-2.
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2. Disconnect wires from the F1 and F2 terminals on the motor using two wrenches to prevent posts from turning.
Set a multimeter to 200 ohms and place the red (+) probe on the F1 terminal and the black (–) probe on the
F2 terminal. The multimeter should indicate continuity. If the reading is incorrect, a possible open field coil or
bad connections at the terminals may be the cause. The motor will need to be removed from the vehicle and
repaired by a qualified technician.
See Motor Removal on page 16-4.
3. If reading is correct, reconnect the motor wires. See Motor Installation on page 16-15.
4. Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
2019 Precedent Villager 2 Maintenance and Service Manual Page 16-3