Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 303 / 414

GASOLINE VEHICLE - ELECTRICAL
COMPONENTS Reverse Buzzer Limit Switch
19
REVERSE BUZZER LIMIT SWITCH
See General Warnings on page 1-2.
TESTING THE REVERSE BUZZER LIMIT SWITCH
See Test Procedure 16 – Reverse Buzzer and Reverse Buzzer Limit Switch on page 18-30.
REVERSE BUZZER LIMIT SWITCH REMOVAL
1. Disconnect battery and spark plug wire(s).
2. Cut the wire tie that retains the limit switch leads to the instrument panel harness.
3. Disconnect the wire connector from the reverse buzzer limit switch (3) located on the back of the Forward/Reverse
shifter assembly.
(Figure 19-22, Page 19-26)
4. Remove the nuts (4) and washers (5) from the reverse buzzer switch (3) and slide the reverse buzzer switch off
of the screws (2).
REVERSE BUZZER LIMIT SWITCH INSTALLATION
1. Install the reverse buzzer limit switch (3) with two screws (2) that attach the buzzer to the shifter assembly.
(Figure 19-22, Page 19-26)
2. Install washers (5) and tighten nuts (4) to 5 in·lb (0.6 N·m).
CAUTION
• Do not overtighten the retaining nuts. If the nuts are over tightened, limit switches could be damaged.
3. Place the Forward/Reverse handle in REVERSE and make sure that both switches actuate.
4. Connect the two wire connector to the reverse buzzer limit switch (3).
5. Connect battery and spark plug wire(s).
6. Shift the Forward/Reverse handle to the REVERSE position. The buzzer should sound.
2019 Precedent Villager 2 Maintenance and Service Manual Page 19-25