Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 291 / 414

GASOLINE VEHICLE - ELECTRICAL
COMPONENTS Starter/Generator
19
1
2
4
3
F1
DF
F2
3033
Figure 19-14 Starter/Generator Wiring
BELT TENSION ADJUSTMENT FOR EFI ENGINES
NOTE: To prevent belt slipping while starting an EFI engine, follow procedure outlined below which is best performed
by two people to expedite the process, but can be performed by a single individual if required.
The amount a starter/generator belt is tensioned varies between a used and new belt.
EFI engines have higher starting torque demands that require consistent belt tension to prevent slipping. Belt tension
should be checked periodically.
Locate gauge midway between pulleys.
2724
Figure 19-15 Belt Tension Gauge
2725
Figure 19-16 Belt Tensioning Tool Installation
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
2. Access engine compartment.
– Remove seat and rear access panel (if equipped).
– Raise cargo bed (if equipped).
2019 Precedent Villager 2 Maintenance and Service Manual Page 19-13