Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 60 / 414

6
Brake Shoe Installation WHEEL BRAKE ASSEMBLIES
BRAKE SHOE INSTALLATION
See General Warnings on page 1-2. See also Asbestos Dust Warning on page 6-1.
1. Turn the adjusting wheel screw so that the shoe slot is vertical, then position the trailing shoe in the slots in the
shoe mounting block and adjuster assembly
(Figure 6-10, Page 6-5) . See following NOTE.
NOTE: The trailing shoe has 17T stamped into the tip of the shoe flange (Figure 6-10, Page 6-5) . The leading shoe is
stamped 17L. When installing the shoes, the stamping on both shoes should be oriented to the top of the
brake assembly. When installing the shoes on the passenger side of the vehicle, the side of the trailing shoe
flange marked 17T should be facing out and be visible. On the driver side, the 17L on the leading shoe should
be facing out and be visible.
When installed on the backing plate, the leading shoe (stamped 17L) is always oriented toward the rear of
the vehicle.
2. Install the shoe retainer clip, using pliers to compress the clip (1) while turning the retainer pin (2) into position
(Figure 6-11, Page 6-6) .
3. Attach the springs onto the trailing shoe already installed. Then hold the leading shoe next to the trailing shoe,
correctly oriented, and attach the springs to it
(Figure 6-12, Page 6-6) .
4
1
2
3
1. Bronze Spring 2. Silver Spring 3. Coils of Silver Spring 4.
Adjustment Lever Spring
NOTE: The silver spring (2) is mounted with the coils (3) to the side of
the adjustment lever spring (4).
2737
Figure 6-11 Install Trailing Shoe Retainer Clip
2738
Figure 6-12 Attach Springs
4. While maintaining spring attachment on both shoes, position tips of leading shoe (1) in the mounting slots and
then push shoe into place. Hold shoe in position and install retaining clip
(Figure 6-13, Page 6-7) .
5. After the shoes are installed, move them together up and down and side to side to make sure that they will easily
slide approximately 1/4 to 3/8 inch (6.3 to 9.5 mm) without binding
(Figure 6-14, Page 6-7) .
Page 6-6 2019 Precedent Villager 2 Maintenance and Service Manual