Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 61 / 414

WHEEL BRAKE ASSEMBLIES Brake Shoe Installation
6
B
A
1
646
Figure 6-13 Install Leading Shoe
647
Figure 6-14 Check Shoe Positions
6. Place a flatblade screwdriver under the adjusting arm (1) and raise the arm off of the adjusting wheel (2). While
holding the arm (1) up, turn the wheel (2) upward until it stops
(Figure 6-15, Page 6-7) . Remove the screwdriver.
1
2
648
Figure 6-15 Set Adjusting Wheel
7. For electric vehicles: Install the axle shaft.
For gasoline vehicles: Install the wheel hub assembly. See Rear Hub Installation, Section 24, Page 24-4.
8. Install the brake drum, and make sure that it is properly seated. See following NOTE.
NOTE: If drum installation is difficult, the brake shoes may need to be adjusted vertically in the mounting slots.
9. After the drum is installed, make sure the axle and drum turn freely and then install the wheel. See Wheel
Installation on page 8-1.
10. Remove the turnbuckle (2) and apply Loctite ® 242 to the threaded ends of both the rod from the pedal group (6)
and the brake actuator rod (5) (Figure 6-18, Page 6-12) . Connect the rods using the turnbuckle. Ensure the ends
of the brake cables do not slip out of the brake equalizer during this procedure.
11. Adjust brake cable equalizer. See Brake Cable Equalizer Adjustment on page 6-8.
2019 Precedent Villager 2 Maintenance and Service Manual Page 6-7