Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 380 / 414

24
Rear Hubs GASOLINE VEHICLE - TRANSAXLE
REAR HUBS
REAR HUB REMOVAL
1. Turn the key switch to the OFF position and remove the key, and place the Forward/Reverse handle in the
NEUTRAL position.
2. Disconnect battery and spark plug wire(s).
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3. Place chocks at the front wheels and loosen lug nuts on both rear wheels.
4. Remove the rubber dust cap (1).
5. Remove and discard the cotter pin (2) (Figure 24-3, Page 24-4) .
6. Remove nut locking cap (3) and loosen the hub nut (4) on the axle shaft.
7. Lift and support the rear of vehicle.
8. Remove the lug nuts and wheel.
9. Slide brake drum off hub.
10. Remove hub nut (4) and large flat washer (5) and pull hub (6) off axle shaft. See following NOTE.
NOTE: If the hub (6) does not slide easily off the axle shaft, use a two or four-jaw wheel puller to remove the hub.
6
1
3
4
5
2
3056
Figure 24-3 Rear Hub Exploded View
REAR HUB INSTALLATION
1. Inspect brake shoes for wear and replace if necessary. See Wheel Brake Assemblies section.
NOTE: If brake shoes are replaced on one side, replace the opposite side also.
2. Clean the splines and threaded portion of the axle shaft.
3. Apply anti-seize compound to both the axle shaft splines and hub (6) splines. See following CAUTION.
Page 24-4 2019 Precedent Villager 2 Maintenance and Service Manual