Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 173 / 414

ELECTRIC VEHICLE - ELECTRICAL
COMPONENTS Electronics Module
13
ELECTRONICS MODULE
See General Warnings on page 1-2.
While it is not necessary to remove the electronics module from the vehicle, access to individual components may be
easier with the module removed.
ELECTRONICS MODULE REMOVAL
1. Disconnect the batteries and discharge the controller (1). See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2. Remove the batteries from the vehicle to provide enough room to access the controller (1) (Figure 13-8, Page
13-10) . See Battery Replacement on page 14-5.
3. Remove the bolt (2) that secures the electronics module (3) to the battery bucket.
4. Pull electronics module (3) forward and disconnect the heavy gauge wires from the controller (1) and solenoid (4).
5. Disconnect the 16-pin connector, 4-pin connector, and spade connectors from the controller (1).
6. Disconnect the spade connectors on the front of the solenoid (4).
7. Disconnect the two wires from Tow/Run switch (5).
8. Lift the electronics module (3) from the vehicle. See following WARNING.
WARNING
• Shorting of battery terminals can cause personal injury or death.
– Do not place component mounting plate directly on top of batteries when removing or installing
plate.
– Remove plate from vehicle completely.
2019 Precedent Villager 2 Maintenance and Service Manual Page 13-9