Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 18 / 414

1
General Warnings SAFETY
(Viewed from driver side of vehicle)
1. Place TOW/RUN Switch in TOW before disconnecting or connecting
battery cables.
2. Remove negative battery cable.
3. Remove positive battery cable.
Connect battery cables in reverse order.
(Viewed from driver side of vehicle)
1. Remove positive terminal cover.
2. Remove negative battery cable.
3. Remove positive battery cable.
Connect battery cables in reverse order.
49A
Figure 1-1 Battery Cable Removal – Electric Vehicles
6x8-Volt Battery Configuration
3167
Figure 1-2 Top-Battery: Battery Cable Removal-Gasoline
Vehicles
DISCONNECTING THE BATTERIES – ELECTRIC VEHICLES
1. Disable the vehicle. See Disabling the Vehicle on page 1-3.
2. Place Tow/Run switch in the TOW position before disconnecting or connecting the batteries. Failure to heed
this warning could result in a battery explosion or severe personal injury.
3. Disconnect the batteries, negative (–) cable first, as shown (Figure 1-1) .
4. After disconnecting the batteries, wait 90 seconds for the controller capacitors to discharge.
CONNECTING THE BATTERIES – ELECTRIC VEHICLES
1. Ensure the Tow/Run switch is in the TOW position.
2. Connect the battery cables, positive (+) cable first.
3. Tighten battery terminals to 110 in·lb (12.4 N·m).
4. Coat terminals with Battery Terminal Protector Spray to minimize corrosion.
Page 1-4 2019 Precedent Villager 2 Maintenance and Service Manual