Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 226 / 414

16
Motor Assembly ELECTRIC VEHICLE - MOTOR
758
Figure 16-16 Brush Rigging
759
Figure 16-17 Retracted Brushes
760
Figure 16-18 Armature Installation
761
Figure 16-19 Brush Setting
3. With the brushes retracted, use an arbor press to press the armature shaft into the end cap bearing (Figure
16-18, Page 16-14) . See following CAUTION.
CAUTION
• Make sure the brushes are held back. Do not allow the brushes to support the weight of the
commutator. The brushes can be easily damaged by this weight.
4. Gently press each brush with a small screwdriver until the spring rests on the end of each brush as shown
(Figure 16-19, Page 16-14) .
5. Align the match marks on the end cap and the motor frame (1) and secure with two bolts (16) (Figure 16-15,
Page 16-12) . Tighten bolts to 130 in·lb (14.7 N·m).
6. Install the speed sensor magnet (24) with screw (23). Tighten to 65 in·lb (7.3 N·m).
7. Install the speed sensor (10) with screws (25). Tighten to 20 in·lb (2.2 N·m).
Page 16-14 2019 Precedent Villager 2 Maintenance and Service Manual