Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 169 / 414

ELECTRIC VEHICLE - ELECTRICAL
COMPONENTS Electronics Module Cover
13
ELECTRONICS MODULE COVER
See General Warnings on page 1-2.
The electronics module cover needs to be removed to gain access to the speed controller, Tow/Run switch, and
solenoid.
ELECTRONICS MODULE COVER REMOVAL
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2. Remove the two plastic rivets (1) that secure the access panel (2) to the vehicle (Figure 13-5, Page 13-6) .
3. Remove cover (5) by first releasing the four tabs (3) from the matching holes in the hood of the battery bucket.
Then, maneuver the cover to release the two hooks (4) that secure the cover to the battery bucket.
CAUTION
• Be careful not to break the two hooks (4) on the bottom of the cover. Push the bottom of the cover up
to release the hooks before pulling cover away from battery bucket.
ELECTRONICS MODULE COVER INSTALLATION
1. Install cover (5) by first hooking the four tabs (3) into the matching holes in the hood of the battery bucket (Figure
13-5, Page 13-6) . Then, use the two hooks (4) to secure the cover to the battery bucket.
2. Place access panel (2) on vehicle and secure with the two plastic rivets (1). See following CAUTION.
CAUTION
• Exposure to water may damage electronic components.
– Do not operate vehicle without this cover properly installed.
– Do not direct water stream in the area of the cover.
3. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-4.
2019 Precedent Villager 2 Maintenance and Service Manual Page 13-5