Claas LEXION 480, Repair Manual

Page: 988 / 1018

10.1.6
RHB LEXION 480 - 188 678.1
Cooling system
Installing the radiator
1. Insert the radiator into the air intake box and bolt
down the brackets (P) at the sides. Fit the locking
plate (S) and the support (T).
(Fig. 13, 14)
2. Tighten the bolts (F and G). Bolt down bracket (L).
(Fig. 12)
3. Connect radiator hoses (K).
(Fig. 11)
4. Swing the oil cooler back into place. Refit the
condenser completely with the hoses. Fit the hose
clamps.
(Fig. 10)
5. Bolt down the cover (B) of the air intake box.
(Fig. 9)
6. Fasten the rotary screen in the pivot and secure
with a bolt. Insert the gas strut bolt and secure
with a split pin.
(Fig. 7)
7. Changing the coolant filter (K) if it is installed:
ATTENTION!
The filter must only be replaced by an
original filter cartridge.
8. Filling in coolant:
Open the shut-off taps of the heater feed and
return lines.
Fill the system with coolant at point (E), until the
level is at the edge. Now let the engine run for a
short period of time.
Stop the engine and check coolant level again.
Top up coolant if required.
(Fig. 15, 16)
15
16