6-49
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 6
Logical Node, Port, and Signaling Commands
cnfsigdiag
-cldaddrmask The the atm-address-mask: Address mask for identifying valid bits of the called
NSAP address field (ff.ff.ff, for example). To match this selection criterion, a failed
connect setup must have a called party address value equal to the configured called
party address for all bits that are 1 in the specified mask.
Default: NULL. NULL means the rejected call matches the filter criteria for any
called address in the rejected call.
-clgaddrmask
The atm-address-mask: Address mask for identifying valid bits of the calling NSAP
address field. (ff.ff.ff, for example). To match this selection criteria, a failed connect
setup must have a calling party address value equal to the configured calling party
address for all bits that are 1 in the specified mask.
Default: NULL means the call matches the filter criteria for any calling address in the
rejected call.
-casttype
Filtering by connection type. The types are point-to-point (p2p), point-to-multipoint
(p2mp)—currently not supported, or both (all)).
Default: all
-clrcause
The clear-cause-code: Filters ATM signaling call failures by the release cause code
(a decimal number) as specified in the ATM Forum UNI 3.1 specification.
Default: 0, meaning the cause code is not considered during filtering.
-connctgy
Filters ATM signaling call failures by virtual circuit category (SPVC, SPVP, SVC,
SVP, or all of these circuit categories).
Default: all
-inport
The portid: filters ATM signaling call failures based on the incoming port of the call.
Default: 0, meaning the incoming port is not considered during filtering.
-outport
The portid: filters ATM signaling call failures based on the outgoing port of the call.
Default: 0, meaning the outgoing port is not considered during filtering.
-maxrec
The max-num-records: the maximum number of records collected for a particular
signaling diagnostics filter table entry. When the maximum value is reached, the older
records are deleted. If this field is set to -1, the records are not overwritten. Setting
this field to -1 increases memory usage for call failure records and can lead to
shortages of available system memory.
Range: –1 through 214783647
Default: 20
-scope
The filtering scope choices are within the switch (int), on other switches (ext), or both
(all).
Default: all
