Cisco FM1200 Volo, Installation And Configuration Manual

Page: 17 / 175

IMPORTANT
VGbe is only supported when the Cisco FM1200 Volo is
configured as a
Mesh End or Mesh Point unit. If the unit is
switched to Bridge mode, VGbe will be disabled.
A representation of the scenarios in which VGbe is active are shown
in
Figure 1 (page 17) below:
Figure 1. Virtual Gigabit implementation scenarios
In the figure above, all data traffic is sent to and from the primary Ethernet
port by default.
If multiple traffic streams (in other words, more than one destination MAC
address) are detected, the unit monitors the aggregate throughput of the
traffic streams. If aggregate throughput exceeds a detected 85 Mbps, one
or more of the traffic streams are 'moved' onto the secondary Ethernet
port, allowing the unit's Ethernet throughput capacity to exceed 100 Mbps
(under optimal wireless link conditions).
3.2.3. Point-to-point wireless bridge
A point-to-point wireless bridge allows two local networks to communicate
with each other. A simplified example is shown in
Figure 2 (page 18) .
In context of the overall network architecture, the two local networks are
called
network segments.
Getting Started
© 2021 Cisco and/or its affiliates. All rights reserved. Page 17 of 175