• The unit's process field net (PROFINET) support settings (if
applicable).
• The unit's Neutrino Qnet (QNET) support settings (if applicable).
To change any of the miscellaneous settings, do the following steps:
1.
Click the
-misc settings
link under
ADVANCED SETTINGS
in
the left-hand settings menu.
• The
MISC SETTINGS
dialog will be shown (
Figure 50. Configurator GUI (MISC SETTINGS dialog)
2.
Set the device name by typing it in the
Name:
field.
NOTE
It is not essential to specify the device name, but it is
strongly recommended. Failure to specify the device
name may make the unit difficult to recognize in
situations where more than one unit is being dealt
with at the same time (for example, when using
utilities such as the FMQuadro network map).
3.
Set the functionality of the unit's hardware
Reset
button by
clicking the
Reset Button function:
drop-down and clicking the
needed option as described below:
•
Disabled:
The hardware
Reset
button will be disabled.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 122 of 175
