Cisco Catalyst 4500 Series, Software Configuration Manual

Page: 676 / 2086

21-8
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 21 Configuring SmartPort Macros
Configuring SmartPort Macros
Applying SmartPort Macros
To apply a SmartPort macro, perform this task:
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# macro global
{
apply
|
trace
}
macro-name
[
parameter
{
value
}]
[
parameter
{
value
}] [
parameter
{
value
}]
Applies each individual command defined in the macro to the switch by
entering
macro global apply macro-name . Specify macro global trace
macro-name to apply and debug a macro to find any syntax or
configuration errors.
(Optional) Specify unique parameter values that are specific to the
switch. You can enter up to three keyword-value pairs. Parameter
keyword matching is case sensitive. All matching occurrences of the
keyword are replaced with the corresponding value.
Some macros might contain keywords that require a parameter value.
Use the
macro global apply macro-name ? command to display a list of
any required values in the macro. If you apply a macro without entering
the keyword values, the commands are invalid and are not applied.
Step 3
Switch(config)# macro global
description text
(Optional) Enters a description about the macro that is applied to the
switch.
Step 4
Switch(config-if)# interface
interface-id
(Optional) Enters interface configuration mode, and specify the
interface on which to apply the macro.
Step 5
Switch(config-if)# default interface
interface-id
(Optional) Clears all configuration from the specified interface.
Step 6
Switch(config-if)# macro
{
apply
|
trace
}
macro-name
[
parameter
{
value
}]
[
parameter
{
value
}] [
parameter
{
value
}]
Applies each individual command defined in the macro to the interface
by entering
macro apply macro-name . Specify macro trace
macro-name to apply and debug a macro to find any syntax or
configuration errors.
(Optional) Specify unique parameter values that are specific to the
interface. You can enter up to three keyword-value pairs. Parameter
keyword matching is case sensitive. All matching occurrences of the
keyword are replaced with the corresponding value.
Some macros might contain keywords that require a parameter value.
Use the
macro apply macro-name ? command to display a list of any
required values in the macro. If you apply a macro without entering the
keyword values, the commands are invalid and are not applied.
For example, here is how you apply this command:
Switch(config-if)# macro apply cisco-phone ?
WORD Keyword to replace with a value e.g. $AVID, $VVID
<cr>
Step 7
Switch(config-if)# macro description
text
(Optional) Enters a description about the macro that is applied to the
interface.
Step 8
Switch(config-if)# end
Returns to privileged EXEC mode.
Step 9
Switch# show parser macro
description
[
interface interface-id
]
Verifies that the macro is applied to the interface.
Step 10
Switch#
copy running-config
startup-config
(Optional) Saves your entries in the configuration file.