Cisco Catalyst 4500 Series, Software Configuration Manual

Page: 1932 / 2086

77-20
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 77 Configuring Call Home
Alert Group Trigger Events and Commands
POWER_FAIL
URE InlinePowerSupplyBad 3 Inline power source from a power supply has failed or
turned off.
POWER_FAIL
URE MixedPowerSupplyInC
hassis 3 Mixed power supplies have been detected in the
chassis.
POWER_FAIL
URE NotEnoughPowerChass
is 6 There is insufficient power to support the system. The
system might shut down.
POWER_
RECOVERY InlinePowerSupplyGoo
d 3 A failed source for inline power has been fixed.
FANTRAY_FA
ILURE FanTrayPartialFailure 3 Either a fan or thermistors in system fan tray has
failed.
FANTRAY_FA
ILURE FanTrayMismatch 3 The fantray, supervisor, chassis combination is
disallowed.
FANTRAY_FA
ILURE FanTrayBad 5 Fan tray has failed.
FANTRAY_
RECOVERY FanTrayGood 3/5 Failed fan tray has been fixed.The severity of the
notification depends on the failure which has been
recovered from.
FANTRAY_
FAILURE InsufficientFantray 6 There are not enough FanTray to support the system.
This may be followed by a system shut down.
CLOCK_ALA
RM ClockSwitchover 2 Clock module has switched over to another clock.
CLOCK_ALA
RM Clock Faulty 3 The clock module has been found to be faulty.
Inventory Inventory status should be provided whenever a unit is
cold-booted, or when FRUs are inserted or removed.
it is considered a noncritical event, and the
information is used for status and entitlement.
CLI commands executed:
show module
show version
show inventory oid
show idprom all
show power
INSERTION Module 1 A line card or supervisor engine has been inserted into
a slot.
REMOVAL Module 1 A line card or supervisor engine has been removed
from a slot.
Table 77-3 Call Home Alert Groups, Events, and Actions (continued)
Alert Group
Call Home
Trigger Event
Syslog Event Severity Description and CLI Commands Executed